Toilet Water Supply Line Leak After Fill Valve Replacement

Water supply line problems.

Toilet water supply line leak after fill valve replacement.

Over time a worn or out of alignment fill valve can become a problem cause a leak and wear on valve s components and parts. The inlet nut holds the valve in place. The fill valve gets blamed for some leaks that are really the fault of the water supply line. 2 the nut that connects the supply line to the shut off valve.

Replace the toilet water supply line and check for leaks. Check the supply line connection to the toilet and tighten if needed. Leaks where the supply line enters the toilet tank. The fill valve is the part of the toilet that is responsible for refilling the tank after being flushed.

Leak was from the supply line and i replaced the water fill valve too. If you see damage or if it is more than 5 years old replace the supply line. If this valve loosens. This valve replenishes the supply of water to the tank after a flush.

The leak may be from worn treads on the fittings. Then carefully pull the supply line out of the valve underneath the tank. If your fill valve leaks or if water continues to run after you flush it may be time to replace the fill valve. Make sure the fill valve assembly is properly secured to the bottom of the tank.

Loosen the nut that secures the fill valve to the water supply line by turning it counterclockwise with pliers or a wrench. Leak was from the supply line and i replaced the water fill valve too. The bottom of the toilet tank has a hole for the fill valve. The tape will help fill in the gap.

We will work from the toilet back to the wall to locate the problem. There are two nuts near the fill valve. Detach the toilet fill valve. As you unscrew the nut a bit of water may drip out of the tank.

Leaks where the tank connects to the. See the article toilet fill valve repair for more information. Toilet supply line leak at the fill valve. Remove the line just like you did in step three.

1 at the nut that connects the supply line to the fill valve. Use a dry rag and your finger to determine which spot is leaking. Check the supply line. Wrap the tape around the treads of the fitting on the toilet and the threads that attach to the water supply.